
recovery of copper from oxide copper ore by flotation and. Dec 2, 2014 Native copper, cuprite (Cu2O), tenorite (CuO), and malachite (Cu2(OH)2/CO3) were the main copper minerals in the test sample. Quartz, calcite, Get Price
More2016-5-16 A Copper Flotation Flowsheet Because the copper in this type of ore usually assays only plus or minus 1% copper, the porphyry copper operations must be relatively large in order to be commercial. The flowsheet in this study illustrates a typical 3,000
MoreThe activation effects of single activator and some combined activators on Yunnan copper oxide ore were studied with Drawing a conclusion that the best activation - xanthate flotation result could be obtained by using sodium sulfide and ethylenediamine phosphate as the combined activator. on this basis, the open and closed circuit flotation tests were done , and in the closed circuit flotation test ,the flotation concentrate with yield of 5.90%, copper
More2016-12-27 For each test-run of the flotation-process,approximately 100 kgs of copper ore was reduced insize to 80% passing 4mm. The crushed material waswet-ground for 20 min in a closed-circuit ballmillclassifier, at a solid-liquid ratio of 1:2.3 (i.e. 30% solidsby weight), to 80% passing 75mm. The coarseparticles were difficult to float, so the grind was chosento be fine i.e. 75mm (Rafiq Mazhar,
MoreA closed-circuit flotation test yielded a copper recovery of 76% with a concentr ate grade of 21.65% TCu . Wang and his colleagues [43 ] reported on the flotation of a Yunnan copper ox ide ore
More2014-12-24 Results of flotation tests were unsuccessful in terms of both recovery and grade of concentrate product. The highest copper recovery of concentrate was found as 61.35% with 8.69% copper content. The concentrate with highest copper grade of 34.65% was obtained with only 26.98% copper recovery.
More2014-10-15 For each flotation test, one kg of the crushed ore has been subjected to wet grinding in ball mill for obtaining granulometry of d 80 of 74 μm and flotation pulp with specific gravity of 1200 g/L. The ore has been initially subjected to talc pre-flotation during 3 min followed by copper–cobalt
More2016-11-22 A test of a slow floating platinum ore, for instance, may require 45 minutes to an hour to reach completion and thus the first concentrate can be collected after two minutes of flotation. A faster floating copper porphyry flotation test, however, may finish in five minutes and a first concentrate may need to be collected after 20 seconds.
More2020-1-8 All the flotation test-work was done using the Denver laboratory machine with a 1.5l stainless steel flotation cell. The required mass of nickel-copper sulphide ore material ground to 70% passing 75 µm was weighed and placed in the flotation cell. This was followed by the addition of distilled water to about 60% of the cell volume before the required volumes of 1% solutions of the collector; SIPX
More2012-11-30 Several N-arylhydroxamic acids were synthesized and tested for the flotation of a copper-zinc ore, and the effect of structure on the flotation efficiency was modeled using the Quantitative Structure-Activity Relationship (QSAR) approach (Natarajan and Nirdosh, 2003).
Morerecovery of copper from oxide copper ore by flotation and. Dec 2, 2014 Native copper, cuprite (Cu2O), tenorite (CuO), and malachite (Cu2(OH)2/CO3) were the main copper minerals in the test sample. Quartz, calcite, Get Price
More2016-12-27 FLOTATION TEST-PROCEDURE AT PILOT SCALE Minerals The copper ore was from the Shinkai area (North Waziristan) and assayed at 0.9% Cu, 0.0134% Zn, 0.0126% Pb, 0.0110% Co, 0.0067% Ni, 1.740 ppm Ag, and 0.22 ppm Au. Quartz was the main gangue mineral. Communition For each test-run of the flotation-process, approximately 100 kgs of copper ore was ...
More2013-12-24 A New Application For Flotation Of Oxidized Copper Ore 69 RESULTS AND DISCUSSION The Flotation of Oxidized Copper Ore: This study was carried out under the conditions indicated in table 1. Flotation time was 3 minutes. In the first test with a run of mine ore sample, it was determined that the concentrate (copper and cobalt) obtained from this ...
More2020-1-8 For each test freshly prepared reagent solutions were used. Distilled water was used in all flotation experiments. Fig.1. X-ray diffraction pattern of the nickel-copper sulphide ore sample Table. 1. Chemical composition of the nickel-copper sulphide ore (mass fraction, %).
More2021-3-18 Flotation of copper sulfide ore. The test was carried out in the flotation cells (XFD-63) with 500 g sample. First, adjust the pH of the suspension with sodium carbonate for 2 min, add depressant ...
More2009-8-27 Table 1: Grade/recovery performance of a hypothetical copper ore flotation process. Product % Weight % Cu Assay Feed 100 2.09 Concentrate 10 20.0 Tailings 90 0.1 (a) From Table 1, the Ratio of Concentration can be calculated as F/C = 100/10 = 10. If only assays are available, the ratio of concentration equals (20 – 0.1)/(2.09 – 0.1) = 10 ...
MoreThe fitting of flotation date to a flotation kinetic equation shows that the copper oxide ore, cuprite, malachite and chrysocolla in this ore are consistent with a first order kinetic equation. The rate constants for copper oxide, cuprite, malachite and chrysocolla are 0.152, 0.104, 0.248 and 0.210 respectively.
More2010-1-19 The flotation of a natural porphyry copper ore with bornite and malachite was investigated via fundamental work with pure minerals and a bench-scale testing regime. The processing of the test ore was problematic due to a mineral assemblage that caused prevalent slime generation.
More2015-7-3 The presence of shale, the source of carbonaceous matter in the ore, has also a negative effect on flotation and pyrometallurgical processes. The presence of clay minerals and organic carbon in shale makes the production of high quality flotation concentrates, without excessive loss of copper and other metals in the flotation tailing, difficult.
MoreThe flotation test for actual ore was carried out in XFG-3L flotation cell. The amount of ore samples in each experiment was 1000 g. The concentrates and tailings obtained by flotation test were dried, weighed and element content analyzed, and the grade and recovery were calculated. The closed-circuit flotation flowsheet was shown in Fig. 4.
More2013-12-24 A New Application For Flotation Of Oxidized Copper Ore 69 RESULTS AND DISCUSSION The Flotation of Oxidized Copper Ore: This study was carried out under the conditions indicated in table 1. Flotation time was 3 minutes. In the first test with a run of mine ore sample, it was determined that the concentrate (copper and cobalt) obtained from this ...
More2021-3-19 ph adjustment test of copper/lead bulk flotation The flotation of the polymetallic sulfide ore of copper, lead, and zinc is generally suitable at alkaline pH conditions. Lime and soda are common agents used in adjusting the pH of the slurry.
More2021-3-18 Flotation of copper sulfide ore. The test was carried out in the flotation cells (XFD-63) with 500 g sample. First, adjust the pH of the suspension with sodium carbonate for 2 min, add depressant ...
More2009-8-27 Table 1: Grade/recovery performance of a hypothetical copper ore flotation process. Product % Weight % Cu Assay Feed 100 2.09 Concentrate 10 20.0 Tailings 90 0.1 (a) From Table 1, the Ratio of Concentration can be calculated as F/C = 100/10 = 10. If only assays are available, the ratio of concentration equals (20 – 0.1)/(2.09 – 0.1) = 10 ...
More2017-2-4 flotation response of a copper cobalt oxide ore sample. The head assay conducted on the initial ore sample showed that it contained about 2.90% of Cu, 0.12% of Co. Upon the flotation test work, the results obtained indicated that the concentrate obtained with use of the mixture gazoil-rinkalore RX
MoreA new method, staged flotation for effectively increasing the recovery of ultra-fine copper oxide ore with a new type of collector (ZH-1, C3-5 carbon chain xanthate) is proposed for the first time. The flotation process and mechanism were examined by flotation tests,
More2018-6-1 It is reported that many small and medium-sized mine owners never pay attention to ore dressing test and mine design in the whole ore dressing process. marketing@ytxinhai. 0086 15311826765. Language. ... Flotation. SF Flotation Cell ...
More2017-3-6 According to the mass balance results (Wightman, 2010), the copper recovery in Cu Rougher concentrate is about 72 %, i.e. 28 % of copper is lost to pyrite flotation circuit. The test results given in Figure 3.15, on the other hand, showed that 5 g/t extra collector addition to Cu Rougher Tail will increase the recovery in copper rougher section ...
More2015-7-3 The presence of shale, the source of carbonaceous matter in the ore, has also a negative effect on flotation and pyrometallurgical processes. The presence of clay minerals and organic carbon in shale makes the production of high quality flotation concentrates, without excessive loss of copper and other metals in the flotation tailing, difficult.
MoreThe flotation test for actual ore was carried out in XFG-3L flotation cell. The amount of ore samples in each experiment was 1000 g. The concentrates and tailings obtained by flotation test were dried, weighed and element content analyzed, and the grade and recovery were calculated. The closed-circuit flotation flowsheet was shown in Fig. 4.
More